HPLC Determination of EDTA on Newcrom B Column


HPLC.cloud
View on hplc.cloud

 

 

EDTA Standards Solution A:
For the preparation of the EDTA standard solution, 5 mg of EDTA was accurately weighed and transferred into a 5 mL volumetric flask and dissolved in 0.001N NaOH water solution with sonication or magnetic stirrer mixing. Filtered The EDTA stock solution (1.0 mg/mL) should be stored in a cold dark place and can be used for a week to prepare standards of required concentration.

Iron(III) chloride Solution B:
The standard stock solution of Iron(III) chloride (10 mg/ml) was prepared in water. 50 mg of FeCl3 was accurately weighed and transferred into a 5 mL volumetric flask and dissolved in water, with sonication if needed.

General procedure for Ferric EDTA complex analysis:
To make a sample for analysis mix 100 µL Solution A (or unknown sample) with 100 µL Solution B and 800 µL of water.  Place this mixture in a plastic HPLC vial for analysis. Setup instrument and column according to the method provided.

Condition

Column Newcrom B, 4.6×150 mm,  100A
Mobile Phase H2O – 99.98%
Buffer H2SO4 – 0.02%
Flow Rate 1.0 ml/min
Detection UV 260nm

Description

Class of Compounds Acid, Hydrophilic
Analyzing Compounds EDTA

 

New more reliable method for EDTA analysis is available

Application Column

Newcrom B

The Newcrom columns are a family of reverse-phase-based columns. Newcrom A, AH, B, and BH are all mixed-mode columns with either positive or negative ion-pairing groups attached to either short (25 Å) or long (100 Å) ligand chains. Newcrom R1 is a special reverse-phase column with low silanol activity.

Select options
SIELC Technologies usually develops more than one method for each compound. Therefore, this particular method may not be the best available method from our portfolio for your specific application. Before you decide to implement this method in your research, please send us an email to research@sielc.com so we can ensure you get optimal results for your compound/s of interest.